Blue point microscan eesc717 manual10/28/2023 If the script is called with MAC address parameter, MAC address found in the configuration file will be ignored, and a script will use MAC address from this parameter. If the script is called with Port parameter, port found in the configuration file will be ignored, and a script will use port from this parameter. If the script is called with IP Address parameter, IP address found in the configuration file will be ignored, and a script will use IP address from this parameter. Device name parameter can not be used in conjunction with IP Address, Port, MAC Address and Timeout command line parameters. If the script is called with Device name parameter, IP address, port, MAC address and timeout parameters found in the General section of the configuration file will be ignored, and a script will use parameters found in a device section of the configuration file. In case the script is called with a command name contained in the configuration file, it will send that command to RM 3 Mini. When defined timout expires, captured IR command will be saved in the configuration file - in the section. After putting RM 3 Mini in the learning state, IR command should be sent to RM 3 Mini (usually a button press on the remote control). If the sript is called with a command name not contained in the configuration file (BlackBeanControl.ini), it will start a learning process.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |